Industry served

Non-Contact Doppler Solid Flow Switch
Flow Meter

Doppler Solid Flow Switch and Microwave Solid Flow Meters are based of state of art technology providing Non Contact measure for Solid Flow/ No Flow and  Continuous Solid Mass Flow Measurement 

Doppler Non Contact Solid Flow Switch

The Doppler Flow Switch emits a low power microwave signal toward the material being monitored. Part of this signal is reflected off the material back to the antenna of the Doppler Flow Switch. This reflected signal combines with the emitted signal to produce a beat

frequency, which is the difference in frequency between the two signals. If the material being monitored is not moving, the reflected signal will be the same frequency as the emitted signal and there will be no beat frequency produced. However, if the material is moving, the reflected signal will be shifted in frequency and a difference or beat frequency will be produced. This shift in frequency is called the Doppler effect. The presence or absence of this beat frequency is sensed by the Doppler Flow Switch to detect a flow or no flow condition.

Microwave Non Contact Solid Flow Meter

The measurement principle of the Microwave Solid Flow Meter is based on the physical Doppler-Effect, whereas the sensor generates a uniform field in the microwave frequency range inside the pipeline. These microwaves are being reflected by particles passing through the pipe. Calculation of frequency and amplitude changes allows an accurate determination of the solid’s mass flow rate. Nonmoving particles like dust accumulation are excluded from calculations.

  • Flow / No Flow detection and Continuous Flow Measurement to prevent cross contamination of ingredients

  • Used for solids, granules, pellets, meals, and powdered materials

  • Installed in distributors, gravity chutes, feeders, pipelines, conveyor belts, or bucket elevators

  • Suitable for most industries, including feed, grain, milling, food, cement, mining, power, and plastics

  • In hazardous locations where there is the threat of combustible dust

  1. FD 2000 – Doppler Flow Switch
  2.  
  3. Dyna M Flow – Microwave Solid Flow Meter

Note : Download the catalogue for more details on the individual models

Power Requirements: 6 Watt at 24 VDC +/-10%

Detection Range: Refer Catalogue

Sensitivity Adjustment: High / low selection switch with potentiometer for Flow Switch and through software for Flow Meter

Note – Refer Catalogue under download section for detailed specifcations

  • Doppler Flow Switch Model FD 2000 for Short Range – Click here to download the catalogue
  • Doppler Flow Switch Model Dyna Guard M for Long Range – Click here to download the catalogue
  • Microwave Solid Flow Meter Model Dyna M Flow – Click here to download the catalogue